Driver sd needs updating ubuntu 3g video hot chat
The new 11.0 system seems to run OK, but there does seem to be an occasional read-write head full-swing excursion that has caught my attention. The dmesg output is below with the hwinfo information for the disk drive that follows: Driver 'sd' needs updating: Driver 'sd' needs updating - please use bus_type methods sd 2:0:0:0: [sda] 625142448 512-byte hardware sectors (320073 MB) sd 2:0:0:0: [sda] Write Protect is off sd 2:0:0:0: [sda] Mode Sense: 00 3a 00 00 sd 2:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA sd 2:0:0:0: [sda] 625142448 512-byte hardware sectors (320073 MB) sd 2:0:0:0: [sda] Write Protect is off sd 2:0:0:0: [sda] Mode Sense: 00 3a 00 00 sd 2:0:0:0: [sda] Write cache: enabled, read cache: enabled, doesn't support DPO or FUA alchemy~/linux/ati-compiz sudo hwinfo --disk 31: IDE 200.0: 10600 Disk [Created at block.234] UDI: /org/freedesktop/Hal/devices/storage_serial_SATA_SAMSUNG_HM320JIS16LJD0PC03486 Unique ID: 3KRlyi73 Parent ID: CLZK.2i Jt Ry_b MBD Sys FS ID: /class/block/sda Sys FS Bus ID: 2:0:0:0 Sys FS Device Link: /devices/pci00/00.0/host2/target2:0:0/2:0:0:0 Hardware Class: disk Model: "SAMSUNG HM320JI" Vendor: "SAMSUNG" Device: "HM320JI" Revision: "2SS0" Serial ID: "S16LJD0PC03486" Driver: "ahci", "sd" Driver Modules: "ahci" Device File: /dev/sda Device Files: /dev/sda, /dev/disk/by-id/scsi-SATA_SAMSUNG_HM320JIS16LJD0PC03486, /dev/disk/by-id/ata-SAMSUNG_HM320JI_S16LJD0PC03486, /dev/disk/by-path/pci-00.0-scsi-0:0:0:0, /dev/disk/by-id/edd-int13_dev80 Device Number: block 8:0- BIOS id: 0x80 Geometry (Logical): CHS 38913/255/63 Size: 625142448 sectors a 512 bytes Geometry (BIOS EDD): CHS 620181/16/63 Size (BIOS EDD): 625142448 sectors Geometry (BIOS Legacy): CHS 1023/255/63 Config Status: cfg=no, avail=yes, need=no, active=unknown Attached to: #24 (SATA controller) Primarily, I have no idea what 'sd' driver should be updated to attempt to correct this issue. dmesg | grep eth [ 2.090548] Driver 'sd' needs updating - please use bus_type methods [ 2.090565] Driver 'sr' needs updating - please use bus_type methods [ 3.685275] eth0: Davicom DM9102 at pci00:0a.0, :ad:01:0e:68, irq 11. Unlike the attached dmesg output, mine contains lots and lots of "eth0: Tx Timeout - resetting" messages. I blacklisted "tulip" module and enabled dmfe module I also used "options dmfe mode=4" to enable full duplex 100mbps I also used "pci=noacpi" boot flag.[ 11.603829] udev: renamed network interface eth0 to eth1 [ 23.467472] ADDRCONF(UP): eth1: link is not ready ifconfig -a eth1 Link encap: Ethernet HWaddr :ad:01:0e:68 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:4 errors:0 dropped:0 overruns:0 carrier:0 Yes, I concur. Hope this is fixed soon so that I can dump my win installation.seconded. Yet, I get "eth0: Tx Timeout - resetting" messages please fix this - we have several machines in our office using this network card. i usually don't check my mail on weekends ;-) Coming to the issue, yes, I still have it on my system, even after upgrading it to Lucid.Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 001 Device 002: ID 8024 Intel Corp.Integrated Rate Matching Hub Bus 002 Device 002: ID 8024 Intel Corp.
Enter the following command to synchronize your package list and install all available updates:sudo apt-get update && sudo apt-get dist-upgrade The command "dist-upgrade" ensures that APT resolves all package dependencies during the upgrade.The Linux kernel includes open-source modules -- i.e.drivers -- for most hardware, and Ubuntu loads these modules from a boot archive called initramfs.You can blacklist unwanted modules or load specific modules by updating initramfs.Press the "Super" key -- also called the Windows key -- then type "Additional Drivers" (without quotes) and press "Enter." If any proprietary drivers are available for your system, Ubuntu finds them and recommends the best ones for your hardware. If proprietary drivers are available for several components, such as wireless cards, video cards or sound cards, you can install drivers for each device.